hi there,
a question popped up regarding usb-hub support. will it be possible to interconnect two usb-midi devices? so for example plug in an usb-midi keyboard and a synth with usb-midi and send data from the keyboard to the synth. what would the latency be like?
thanks
new firmware will have hub support, code is already in dev version.
yes you can send data between devices , there is also a new way of identifying devices in patches.
Latency is fine as far as I can tell, I don’t think any more than if you plugged in directly really.
ok, thanks @thetechnobear! my question regarding latency was geared towards interconnecting devices. will there be additional processing latency from usb to usb? (something like 1.3ms as for audio) or is this handled on a lower level? anyways, exciting stuff!!
wow big ups for implementing this guys! This will make bigger setups with multiple axolotis and controllers a lot easier 
No they are not supported. There have not been any updated in a very, very long time.
There are experimental versions on github, but you have to build them yourself. And from what I understand they are buggy.
If you want to use more midi devices, you can just connect them to a computer and then use this program to route the midi to axoloti:
http://notahat.com/midi_patchbay/
Thanks for the reply! So it’s a matter of the Axoloti not knowing what MIDI messages are meant for it? Hence the need for some routing?
What about using a RaspPi to provide that routing? Would that work or has someone tried that?
Check the Post by @logsol in this thread https://sebiik.github.io/community.axoloti.com.backup/t/raspberry-pi-as-hub-for-usb-midi-devices-advice/3110/2
